Replacement Necksgen Hardware compatible with all models.
All SA 2015 and SA2020 helmets have the 6mm back plate installed for easy Head and Neck Restraint hardware installation. If you purchase a new SA rated helmet andhead and neck restraintorhardware only, we will install the hardware free of charge, please enter in the notes that you would like hardware installed.
I've used three sets of this hardware, two that I installed my self on helmets that I needed to retrofit, and the latest on a new helmet that I had PCI install for me. The installation is very simple, drill holes and bolt in. You do have to take cheek pads and work underneath the lining and such to bolt in though. I decided to have PCI just do it on my new helmet since they were putting the ear cups and radio pieces in. Seemed silly to take that all apart right after they put it all together, so even though easy enough to do, I had them do it to my new helmet. Function wise they work great. I can put the clips in and out myself with the helmet on. Easy pull on the release string and your free from the brace. The plug in angle is easy to figure out even though you can't see with the helmet on. It just sits in a natural spot and I can plug them in no problem.
B
Bubba Jimenez (Phoenix, US)
NECKSGEN HARDWARE
I just recently purchased the NECKSGEN hardware. It could’ve been easier to install. I have a carbon fiber SIMPSON helmet with predrilled holes (from factory). It took me about 5 mins to take off the HANS hardware and install the NECKSGEN. Gunna give it a test this weekend and if all goes well... I’ll be putting it through the ringer at The Parker Race.
Choosing a selection results in a full page refresh.
